Description
12 Volt resistor replacement load for the adaptation of light emitting diode (LED) trailer lamps at vehicles with incandescent lamp monitoring. The direction indicator lamps and the contacts 9 to 13 are looped. LED-ADAPT must be mounted on a metal surface. Important: The direction indicators must be incandescent lamps or LEDs with own monitoring. Other lines may have additional load of 10W maximum, in this case monitoring is disabled.
Features/Details
- ready for use solution with 13 pin standard connectors
- configuration: "2 incandescent lamps + 5 LED + contacts 9 to 13"
- no cable work needed
- the additional pins 9 to 13 are looped
- retrofitting for a factory finished trailer in case of incompability with a new vehicle
- failure of an LED is detected (if no incandescent lamp is connected in parallel)
Product data
Specification
Product number: 11203
- Operation voltage
- 12V nominal
- Output current
- 0.8A (Over current protection time delay 1...2000s !)
- Connection input
- male connector 13 pin 12V ISO'11446
- Connection output
- female socket with flap cover 13 pin 12V ISO'11446
- Load imitation
- 2x4W (rear lamps), 1x34W (stop light) 1x17W (fog lamp), 1x17W (reversing lamp)
- Cable length input
- app. 3300mm
- Cable length output
- app. 600mm
- Temperature range
- -40 ... +75°C
- Electrical protection
- overcurrent, overtemperature, reverse polarity
- Mechanical protection
- IP 6K9K (entirely sealed)
- Dimensions
- 280 x 70 x 25mm without cable outlet
- Mass
- app. 2,80 kg
- Failure monitor LEDs
- 3mA (rear lamp) 8mA (stop light) 8mA (fog lamp) 20mA (reversing lamp)
- Mounting rule
- cooling plate 8dm² (aluminium sheet 1.5mm thickness) or on chassis frame, lamp configuration only 2 x incandescent lamps + 5xLED(+0...10W)
- Approval
- E1 10R-046841