Description
24 Volt resistor replacement load for the adaptation of light emitting diode (LED) trailer lamps at vehicles with incandescent lamp monitoring. The failure of a LED unit is indicated and the replacement load is turned off. LED-ADAPT must be mounted on a metal surface.
***CAUTION***
The connection of any bulb on the output is prohibited. The over current protection may cut off not until after several minutes!
Features/Details
- simply connect ahead of LED lamps
- LED-failure is indicated
- short circuit is indicated
- serves all lines with replacement resistors
- input cable 3,5m can be connected directly to the plug
Product data
Specification
Product number: 11201
- Operation voltage
- 24V nominal
- Output current
- 0.4A (Over current protection time delay 1...2000s !)
- Connection input
- sheathed cable 8x1mm², open cable ends
- Connection output
- sheathed cable 8x1mm², open cable ends
- Load imitation
- 2x17 W (direction), 2x4W (rear lamp), 1x34W (stop light) 1x17W (fog lamp), 1x17W (reversing lamp)
- Cable length input
- app. 3500mm
- Cable length output
- app. 1200mm
- Temperature range
- -40 ... +75°C
- Electrical protection
- overcurrent, overtemperature, reverse polarity
- Mechanical protection
- IP 6K9K (entirely sealed)
- Dimensions
- 280 x 70 x 25mm without cable outlet
- Mass
- app. 1,58 kg
- Failure monitor LEDs
- 20mA (direction) 3mA (rear lamp) 8mA (stop light) 8mA (fog lamp) 20mA (reversing lamp)
- Mounting rule
- cooling plate 8dm² (aluminium sheet 1.5mm thikness) or on chassis frame
- Approval
- E1 10R-046841